Acer eRecovery и способы восстановления системы - 307 страница

Here's some of the steps from Intel's note. Assume you already have a 4Gb or more unallocated space on your SSD drive. For my case, I'd allocated 8192Mb

Configure Intel Rapid Start Technology in BIOS Setup (Depend on make and bios version)
-Press the F2 key during boot up to enter the Intel® Visual BIOS.
-Click on Advanced Setup, and then click on Power.
-Locate the setting for Intel Rapid Start Technology and click on the check box to enable it.
-Set Hibernation Timer to Immediately.
-Press the F10 key to save settings and restart the system.


Create a Primary Store Partition on the SSD
-In the OS, click the Windows Start button.
-In the Search box, type in cmd.exe.
-Right-click on the cmd tool and select Run as administrator. (optional depend on if you got UAC on or not)
-A command line utility will open. Type in diskpart.exe and press Enter.
-At the diskpart prompt, type the following commands as shown:
DISKPART> list disk
Note: If this is an EFI OS (GPT format disk), then you will see an asterisk under the column GPT
DISKPART> select disk X
(X is the disk number where you want to create the hibernation partition. Refer to results from “list disk” for exact disk number. Disk must be a SSD)
DISKPART> create partition primary size=YYYY
(YYYY is the hibernation partition size in megabytes larger than the amount of memory installed on the system. As an example, for 4 GB of system memory, the value should be 4096 or higher)
DISKPART> detail disk
DISKPART> select Volume Z
(Z is the newly created RAW partition. Refer to results from “detail disk” for exact volume number)
DISKPART> set id=D3BFE2DE-3DAF-11DF-BA40-E3A556D89593
DISKPART>exit


The key here is select Volume and set the ID. After that is done, you MUST restart your computer. After that you should able to install the Intel Rapid Start software.